Permanent Papel Picado Banner

I am working on spiffing up my art show display table for the Tucson Open Studio Tour on November 10 & 11.  So I made a table cover and it was missing something.  Well being that it is the time of year for Dia de Los Muertos, I was inspired by the tissue paper cut-out banners. I wanted the same festive look, but a little more enduring.  Here is what I came up with:

Supplies & tools:

Cotton fabric & thread

Sew in interfacing

Paper (I used just printing paper, but water soluble water would have been better)

Cord (I used clothesline rope)

Sewing machine

1 - I drew out a pattern on the paper, remember it's supposed to look like a cut-out so you need to think of shapes that wouldn't fall out if cut out. Also, they tend to be symmetrical as if they were cut out of folds.

2 - I then sandwiched four layers: the bottom/back layer, the interfacing, the "hole" layer, then the top fabric layer and finally the pattern.

3 - I cut around the paper, leaving a flap from the top fabric layer, that would fold over to create the tube to run the cord through.

I folder this over to the back before I stitched all the way around.

4 - I then sewed around the whole paper about 1/4 of an inch inside.

Sewing along the paper, with the top fabric layer folded under to create the tube.

5 - Next I sewed on the pattern, following my lines as best I could.  I sometimes needed to use free stitching, by dropping the feed dogs and removing the sewing foot. This takes some practice, but I have done it enough when quilting, though I am not a pro.

6 - Remove as much of the paper as possible by soaking it in the sink.

7 -  I then washed it in the washing machine to try to remove all the paper.  Not all of the paper came off, it's especially noticable on the darker fabric.  Water-soluble paper would work better.

8 - Then I carefully cut out the top layer (the yellow in this case), inside all the sewing shapes.

Here is the finished banner:

Pin It

Pretty Fabric Lamp

Supplies:

Lamp with wire frame - I got mine at Goodwill

Spray paint - if you want to change the color of the lamp base

Scraps of fabric - I cut strips about 1.5 inches wide and a variety of lengths (from 6 inches)

1 - If desired, spray paint the base, I used these directions as a guide (Directions to paint a lamp).

2 - Remove the fabric or paper from the lamp shade, exposing the wire frame.

3 - Starting along the bottom, tie one end of a piece of scrap on a vertical wire.  Go across to the next vertical wire and tie it.  I just used a single knot, and it seems to hold fine.  If the lamp might be moved a lot or touched a lot do a square knot.  I trimmed all the fabric when I was done. The frayed edges and some loose threads are part of it's charm.

4 - Just keep going around and around. So simple and looks great when lit up.

Pin It